sensors.exdroid.so that loads mxc622x is all i need for my Share MID-2330-S....
i need the one that has a correct address that points to the right module address for the script configs to work.
i pulled the ics sensors.exdroid.so that worked but stucks on boot if i use it to the cookedrom had to reflash again. its maybe because it has different language sets i cant be sure... i don't use linux cuz my laptop cant support it...i attached the ics ver that worked.
i didnt use the stock rom ics that i downloaded cuz i cant make the dualcam to work correctlyhttp://ele-china.com/soft/tablet/7inchA13/201210/Q8-mxc622x-20121101.img
link to share ics single cam replacement rom
crane-evb stock rom
if i could find a good JB sensors.exdroid.so i'll detail everything i did. iwas long but i can compress it hehe
i cant get faaastjb 2.5 to work cuz it just wont load my driver modules... and only for single cam....
8gb partition worked too but because cwm recovery dont support 8gb part ''''dont reboot to recovery unless you have the right cwm ver.that works..'''' if 4gb-8gb is lost, its your device that has the problem try pulling the chip.